Back 2 Lay the Late Mover Guardian Automation Bot
- tootatoota
- Posts: 56
- Joined: Fri Apr 17, 2020 2:33 am
Thanks shaun i thought that related to somethingelse
Hi guys, in the original automation file the signal sets when the price reduces by 5%.
I would like to know if the signal can be reset if the price were to reverse back above that 3.35 theshold (and can be activated again, should it go below 3.35)
I was looking at the clear signal command but don't know how to make it work as above (if at all it does)
Many thanks
I would like to know if the signal can be reset if the price were to reverse back above that 3.35 theshold (and can be activated again, should it go below 3.35)
I was looking at the clear signal command but don't know how to make it work as above (if at all it does)
Many thanks
Yes, first you'll need to add a Stored Value of the price to the first rulesmd100 wrote: ↑Fri May 01, 2020 6:26 amHi guys, in the original automation file the signal sets when the price reduces by 5%.
I would like to know if the signal can be reset if the price were to reverse back above that 3.35 theshold (and can be activated again, should it go below 3.35)
I was looking at the clear signal command but don't know how to make it work as above (if at all it does)
Many thanks
Then you'll need a new 'Set/Modify Stored Value rule' and on the SV tab reset the Stored value named (the orginal SV)
This rule will need the following condition
Stored Value Condition
Is the price greater
Than Another Stored Value (enter the SV you've just added to the first rule)