Automation help please

[HUGO22]

Hi

Just looking for a bit of advice if anybody can help at all please.

I am trying to set up a simple automation file, concentrating only on 1 selection in a horse race which would just before the off either lay the selection if above a pre set price of mine or alternatively to back the selection if is below the pre determined price.

I thought that I set it up up all fine.....Just gave it a try and due to the selection being above my set price it layed as it should have done....all good.

However, in play, it then backed a totally different selection which fell below the set price.

If the selection already has a back or a lay then I just want to leave it at that, and to clarify, I am only concentrating on a single runner.

Regards, Paul

[Dallas]

I would start by changing the times to only allow each rule to run pre-race
But adding the following condition to each will do the job

"Number of Matched Bets Condition"
on "Selection"
is "Equal" to 0

[HUGO22]

I'll give that a go Dallas, sure it will do the trick. Thanks once again. All the best!