Delaying the "Stop" part of offset bet and green

[dm1900]

Hi,

Is it possible to delay the stop loss from being activating till x seconds after in play?

I've got Guardian taking BSP and setting the offset bet with greening, setting it to also keep it when race goes into play. I would like a stop loss too, but this to only occur about 2 seconds after the race goes into play - is there any way to enforce this?

Also - when I use the normal offset bet with greening and stop - if a stop loss is activated then it doesn't seem to green up on the stop loss, but rather once its triggered i see that I will win some money on all other selections, and a large loss on the current selection if it wins?

As you can see in the image, the stop loss was triggered but it hasn't like "hedged up on it"? How do I basically make it press the button the arrow is pointing it?

Thank yoU!

[Dallas]

Both the offset and stop will become active from the time the opening bet is placed.

Stops are never guaranteed to be matched especially on volatile IR markets, see the link below for further details on how to use them more effectively
http://www.betangel.com/forum/viewtopic ... 47&t=11746

[dm1900]

Both the offset and stop will become active from the time the opening bet is placed.

Stops are never guaranteed to be matched especially on volatile IR markets, see the link below for further details on how to use them more effectively
http://www.betangel.com/forum/viewtopic ... 47&t=11746

Hmmm - there was very little volatility though, and the correct stop loss bet did get matched. Is there a way to force guardian to press that button everytime the stop loss is triggered? I am placing sequential bets, i.e.

1. back with offset and greening and stop
2. Once that trade is complete, I redo that loop, regardless if it greened up for a profit or if the stop loss was triggered.

Is it possible to make it press the "green up" button after step 1?

[Dallas]

Stop losses use your offset value so an addition green up (either manually or via automation) will always be required for a completely equal loss across all sections.
Once that's completed you can place an additional bet whenever you want and start the process again from the begining

[dm1900]

Stop losses use your offset value so an addition green up (either manually or via automation) will always be required for a completely equal loss across all sections.
Once that's completed you can place an additional bet whenever you want and start the process again from the begining

Hmmm, I am using a green all rule to do that now, but it seems quite difficult to sync it all together to get it to repeat. I have the following:

Place a back bet (offset greening with stop) if:
- number of unmatched bets = 0

Green all if:
- Number of unmatched bets = 0
- Number of matched bets > 1 (makes sure this only fires if the above rule fired)

It works if I telll them to only fire once, however not sure how to make it fire the back bet again IF it's finished the green up step Especially as I have it manually greening up twice in succession to properly hedge across all selections.

I just want it to back -> offset green / stop -> hedge up -> repeat

But I cannot see how to do that