Fill or Kill Bet Time Rule Condition Logic

[BettingAndBotting]

I'm trying to clear a Signal after a bet has either been filled or killed using the time-based condition in automation as described in the User Guide as...

Fill or Kill Bet Time

This condition allows the automation rule's trigger to be filtered by the amount of time since Bet Angel was last managing a fill or kill bet on the selection.

This condition is particularly useful when trying to prevent unwanted second bets from triggering on a selection when using global settings and offsets. There will be a delay between the initial bet being filled and the offset bet being visible as an unmatched bet in the market (the exact time being based on in-play betting delays and Guardian refresh rates); during that time the Number of Unmatched Bets condition would see no bets in the market, potentially allowing a new bet to trigger. To avoid an unwanted second bet, it is recommended that this condition be used to cover the time before the it is known whether the offset bet has filled or not.

I cannot figure out if the timing on this condition starts when the bet is placed or when the bet is either filled or killed. I'm getting mixed results. Usually if I set the condition to greater than 15 seconds "since the selection contained an active fill or kill bet", it triggers immediately. Frustrating.

Any thoughts?

[BettingAndBotting]

Looking in Gaurdian to apply a condition such as "time since bet placed in market" condition.

There is a condition based on time since market contained a fill or kill bet. I guess I could increment a stored value etc at the time of bet placement and then use a condition based of time since stored value changed - but was hoping for a direct cut through.

This workaround solved my problem... If I increment a signal at the time Bet is placed (with a 30 second fill/kill), then in a separate rule I can take another action 40 seconds after that increment using Signal Changed Condition.