Close Trade If In Loss Over 10 Secs Guardian Automation Bot

[DaveJessop]

Thanks mate - changed the rearm to 2 seconds on the stop loss - I also have it set to close trade on selection with greening on position 3 (fixed order by favouritism before the lay bet and the lay is position 3)

As long as the stop loss catches the majority of losers and not run to a full loss I'll be happy

[DaveJessop]

Seems to work a lot better with the 2 second re-arm - 5/6 today with the stop loss kicking in at 2.50 (set to <3.0) although the horse did fade again and lost it proved that the SL worked and did avoid a potential full loss - produced 5% ROI on today's selections

Happy with that - thanks for your help

[Dallas]

Seems to work a lot better with the 2 second re-arm - 5/6 today with the stop loss kicking in at 2.50 (set to <3.0) although the horse did fade again and lost it proved that the SL worked and did avoid a potential full loss - produced 5% ROI on today's selections

Happy with that - thanks for your help

[Oscar]

Hi Dallas, or anyone out there who is familiar with this bot,

I downloaded this bot and changed a few of it's values. Then I wanted to try something different so I deleted it.
The thing is, when I try to upload it again, now it only has 3 rules;
Signal if in Loss
Reset Sig when in Profit
Green up Selection
Am I missing the "bet" rule? You say that the parameters can be changed so I'm sure there must have been a back or lay bet rule in there somewhere.
It's probably something reeeally obvious.

Thanks in advance for any help

[Dabbla]

There are only 3 rules., It monitors you manual bets.

[Oscar]

Many thanks Dabbla,

That was indeed a duh moment

[LilBobz]

Is there a way to set this to trigger when my loss hits 20% of whatever my liability is on a race (rather than at a fixed monetary amount)?

[Dallas]

Is there a way to set this to trigger when my loss hits 20% of whatever my liability is on a race (rather than at a fixed monetary amount)?

Yes, you can store your loss (liability) against a selection as a Stored Value then adjust it by the percentage you want, then test the trade loss against that.

You'd need a Stored value rule to Store the P/L of the selection
and near the bottom of the Stored Value window use the adjustment by percentage

Then on the existing rules change it from the profit amount to look at the Stored value you've just created

[LilBobz]

Great, will give it a try.

[Dallas]

Great, will give it a try.

If you get stuck just post back

[LilBobz]

Great, will give it a try.

If you get stuck just post back

Many thanks. I've attached some screenshots showing which bits of the automation I have amended. Does this look right?

[LilBobz]

Two more screenshots

[LilBobz]

Think I have already spotted some errors in my rules file.

On the 'Signal if in Loss' rule I have now updated the Green All profit condition to 'less than' the stored value.

I'm also unsure if the Store P/L stored values rule should be saying -20%, 20% or 120% (I want it to trigger at a 20% of my liability loss) .

[Dallas]

Think I have already spotted some errors in my rules file.

On the 'Signal if in Loss' rule I have now updated the Green All profit condition to 'less than' the stored value.

I'm also unsure if the Store P/L stored values rule should be saying -20%, 20% or 120% (I want it to trigger at a 20% of my liability loss) .

The adjustment on the SV should be minus 80%

That will leave a value of 20% which the condition would then look at

[LilBobz]

Think I have already spotted some errors in my rules file.

On the 'Signal if in Loss' rule I have now updated the Green All profit condition to 'less than' the stored value.

I'm also unsure if the Store P/L stored values rule should be saying -20%, 20% or 120% (I want it to trigger at a 20% of my liability loss) .

The adjustment on the SV should be minus 80%

That will leave a value of 20% which the condition would then look at

Thanks, I will give that a try later on today.