Hi all,
I looked at the thread about signals created by Dallas (viewtopic.php?f=50&t=12490) and tried to implement it for creating an automation that accomplishes the following:
1. Lay over 2.5 goals between forty-five seconds before kick-off until kick-off, at the best market price
2. If two goals are scored, close trade with a hedge bet.
3. Else, hedge up at half time.
When I tested this in Practice mode, the trade hedged up after only one goal and I'm not sure what I'm missing. I've attached screenshots (in two separate posts) showing how I set up the goals signal and the hedge-bet-if-two-goals-are-scored rule.
May someone please help me figure this out?
SCREENSHOTS OF SIGNAL SETUP (see next post for the other screenshots)
Signal for 2 goals not working...?
-
eatyourgreens
- Posts: 282
- Joined: Sun Feb 18, 2018 12:53 am
hi Seb,
I have only had a quick look at the screen shots you have posted but in your first screenshot the "goals scored" is set to trigger twice (60 sec re arm), so it is firing after a goal if conditions are met, then 60 secs later it is firing again because conditions are still met. That results in your signal being = to 2, and your green up will then trigger after one goal.
Stay safe!
have a nice day
I have only had a quick look at the screen shots you have posted but in your first screenshot the "goals scored" is set to trigger twice (60 sec re arm), so it is firing after a goal if conditions are met, then 60 secs later it is firing again because conditions are still met. That results in your signal being = to 2, and your green up will then trigger after one goal.
Stay safe!
have a nice day
Thanks for the response and for highlighting that! I now understand why the signal is firing twice in quick succession.
However, I can't seem to set up the signal properly that increments every time a goal is scored. I even reset the settings back to how Dallas had it set up (link to Dallas' post in my first message) to no avail.
Could someone please assist me with what I need to change to get the signal to fire every time a goal is scored?
However, I can't seem to set up the signal properly that increments every time a goal is scored. I even reset the settings back to how Dallas had it set up (link to Dallas' post in my first message) to no avail.
Could someone please assist me with what I need to change to get the signal to fire every time a goal is scored?
I've just realised I can attached the automation file, instead of just screenshots.
I'd really appreciate any help in getting the rule to execute as intended (see first post)
I'd really appreciate any help in getting the rule to execute as intended (see first post)
You do not have the required permissions to view the files attached to this post.