Unmatched Bets Condition

[nicholson3003]

My system involves making a BACK bet and when, and only when, that bet is fully filled, place an offsetting LAY bet. Then rinse and repeat several times. To achieve this outcome I have included a Number of Unmatched Bets condition such that the unmatched bets on the selection is equal to 0. Unfortunately, that doesn't work and I often end up with two or more back bets being placed before the first offsetting bet has been completely filled.

Any help would be much appreciated.

[ODPaul82]

If you apply fill or kill on the bet then it should work

[nicholson3003]

I have the parameters set such that the global settings provide for an offset of 4 ticks with Place fill or kill bets ticked, 30 second delay, one offset. I still often end up with two or more back bets above the number of lay bets whereas I do not want that to happen EVER. I don't want the second (or later) back bet to be placed until the corresponding offset bet has been fully filled. Obviously, that may never happen but it would mean that the bet would simply end there and then.

I guess that if the lay bet was only partially filled then that would show an unmatched bet condition of 0 when, in fact, I want it to complete the fill before entering another back bet.

[Dallas]

I have the parameters set such that the global settings provide for an offset of 4 ticks with Place fill or kill bets ticked, 30 second delay, one offset. I still often end up with two or more back bets above the number of lay bets whereas I do not want that to happen EVER. I don't want the second (or later) back bet to be placed until the corresponding offset bet has been fully filled. Obviously, that may never happen but it would mean that the bet would simply end there and then.

I guess that if the lay bet was only partially filled then that would show an unmatched bet condition of 0 when, in fact, I want it to complete the fill before entering another back bet.

It would need to be completely filled to satisfy a unmatched bet condition of 0

Try adding a 'Fill or Kill Bet Time' Condition
That will prevent further bets being placed between your opening bet being filled and your offset being placed

[nicholson3003]

Thanks. How would I complete the required variables for "The time since the selection contained an active fill or kill bet " Less than, greater than, equal - how many seconds?

[Dallas]

Thanks. How would I complete the required variables for "The time since the selection contained an active fill or kill bet " Less than, greater than, equal - how many seconds?

If its pre-off then greater than 1 second will do it
If its in-play use whatever time the in-play delay is plus 1 second (or double it plus 1 second if using stakes below the £2 minimum)