Volume% & Volume% change

[Waftycrancker]

Hi,

I'll apologise in advance if this doesn't make sense!

Obviously by stored values you can get volume% of a selection and volume% change. Is it possible to set a signal or something simular is say the change% is equal to 50% of volume%. So if a selections overall volume is say 30.00 and the change% is 15.00 signal set?

I'd imagine if possible it's something to do with stored values but can't figure it out.
Thank you

[Derek27]

Hi,

I'll apologise in advance if this doesn't make sense!

Obviously by stored values you can get volume% of a selection and volume% change. Is it possible to set a signal or something simular is say the change% is equal to 50% of volume%. So if a selections overall volume is say 30.00 and the change% is 15.00 signal set?

I'd imagine if possible it's something to do with stored values but can't figure it out.
Thank you

Yes. You can store the volume in a history list at appropriate intervals and have a rule to set a signal. The rule can have a condition to fire when the volume is greater than the volume n seconds ago times, for example, 1.15 if you want to use 15% as the benchmark.

[Dallas]

Here you go, you just need to change the stored values from storing the volume to store the Volume% (and set the relative % change you want to see)
viewtopic.php?f=66&t=16754