CURRENT PRICE AS TICK NUMBER

[Rollox]

Hello was wondering if automation can do this, if current price is 1.01,can it be stored as tick number 1, 1.02 as 2 1.03 as 3 and so on. Was trying to figure it out but going round in circles.
Many thanks
Rollox

[Dallas]

This was added to the Stored Values in the latest version of Bet Angel V1.61
viewtopic.php?f=46&t=27763

[Rollox]

Many thanks Dallas I am still on version 1.6 downloaded from main screen. Can version 1.61 only be downloaded from link above as it's beta?

[Dallas]

Many thanks Dallas I am still on version 1.6 downloaded from main screen. Can version 1.61 only be downloaded from link above as it's beta?

Yes, although its a beta before it's released on the forum it goes through months of in depth testing during development so any obvious and widespread bugs are already delt with long before its given to the community.

Only reason for releasing to the forum community for a few weeks before the official release is to find any deeply hidden or obscure bugs that might exist as the community will use it in a wide way and collectively very little stone is left unturned
For example, when a specfic saved layout is used to display with a new stored value that has a value less than 0 the sum of a stored value can't make the correct calculation - that's the type of bugs the beta is looking to uncover

Up to now there hasn't even been any reported in this beta

[Rollox]

Many thanks Dallas

[PeterLe]

This was added to the Stored Values in the latest version of Bet Angel V1.61
viewtopic.php?f=46&t=27763

Dallas, As far as I can tell, you still cant use this SV tick value in the parameters>global settings?
You can still only specify the offset as either "ticks or %" not a Stored Value
Is that likely to be added in a future release?
Thanks

[Dallas]

This was added to the Stored Values in the latest version of Bet Angel V1.61
viewtopic.php?f=46&t=27763

Dallas, As far as I can tell, you still cant use this SV tick value in the parameters>global settings?
You can still only specify the offset as either "ticks or %" not a Stored Value
Is that likely to be added in a future release?
Thanks

Not yet available as a Global setting, but now the option is there in SV's it' should be easier to roll out in to other areas in up coming builds