AUTOMATION HELP

[brianpotter]

Can anyone point me in the right direction i require a piece of automation so i can lay a selection once the BSP is known at a specified price.

For example i wish to lay Horse A if its BSP price at the off is higher than 3.73, i also want to use liability staking so i can risk a set amount , is there a rules file that can be created that can do that

Thanks as always in advance for any help anyone can give

[ODPaul82]

You could check once market goes in-play with fixed odds condition if the Actual BSP is greater than your set amount, however remember the price may spike up or down so there is no guarantee you will get matched at that actual BSP value.

Liability staking can be set in the parameters section of the rule.

If it is a selection you have identified before the race you can set it as a nominated selection in guardian and then just trigger against selected nomination

[brianpotter]

Thanks Paul very new to the automation side have used one or two files that people have posted , i appreciate it may spike up or down at the off i am looking at named selections and understand that i can nominate those ,it just the rules file i need help with . I set place lay bet 1 second after race goes in play i apllie it to my named selection and set parameters to liability back and lay . How do i set it to fire at greater than a specfic price at BSP , thanks in advance

[ODPaul82]

Conditions Tab, add a new condition, Fixed Odds Condition, selection nominated, the selections Actual SP, greater than, 3.73

You may want to have time from inplay to cover a period of few seconds in case there is a delay in the SP coming through either from BA themselves or dependent on your refresh rate that you have set in Guardian.

[brianpotter]

Thanks Paul think i am getting the hang of this, i will want to set up a few f these every day with different BSP price stipulations , the rules would be the same just the price would be different on each one can i do this ?

[sionascaig]

Probably the easiest way to do it is to use a CSV file that the automation reads in with the list of runners you are interested in with corresponding BSP rate you want to check against.

So automation will check actual BSP with the rate you provide in file..

There is a CSV template you need to use to import to BA automation (see user guide) and is should just be a case of preparing that file at the start of each day and no need to make bespoke changes to your automation.

[brianpotter]

Now you are getting very technical

[brianpotter]

Probably the easiest way to do it is to use a CSV file that the automation reads in with the list of runners you are interested in with corresponding BSP rate you want to check against.

So automation will check actual BSP with the rate you provide in file..

There is a CSV template you need to use to import to BA automation (see user guide) and is should just be a case of preparing that file at the start of each day and no need to make bespoke changes to your automation.

Hi Siona have sent you a PM