Rules about number of Matched and Unmachted Bets don't work inplay

[iueafshk]

Hello.
I need to put stakes INPLAY one horse - one stake (fixed odds <5) for example.
Have three rules:
Fixed Odds < 5
Number of Macthed Bets condition on the selection = 0 Selection Current (Any selection)
Number of Unacthed Bets condition on the selection = 0 Selection Current (Any selection)

and BetAngel put TWO stakes on every horse under fixed odds condition. Not every race, but often. Also I have "Wait 5 seconds before rearming"

[jamesedwards]

Hello.
I need to put stakes INPLAY one horse - one stake (fixed odds <5) for example.
Have three rules:
Fixed Odds < 5
Number of Macthed Bets condition on the selection = 0 Selection Current (Any selection)
Number of Unacthed Bets condition on the selection = 0 Selection Current (Any selection)

and BetAngel put TWO stakes on every horse under fixed odds condition. Not every race, but often. Also I have "Wait 5 seconds before rearming"

There is a 1 second delay when betting into an in-play horse race. Most likely it's triggering a second time before the initial bet hits the market and becomes visible as a matched or unmatched bet.

Try using a stored value that sets when a bet is placed and use this as a condition (SV is not set with a value) on your trigger. This will stop it triggering more than once.

[markzily]

It appears I'm encountering an issue with BetAngel where despite setting rules for one stake per horse in-play with fixed odds under 5 and no matched or unmatched bets, two stakes are occasionally placed on horses. This happens sporadically, even with the "Wait 5 seconds before rearming" option enabled. Has anyone else experienced this or found a solution? Thanks!