Football Signals

[leewillo75]

Need some advice as not sure if this is possible or not.

Basically I run a model of laying under 1.5 goals in certain leagues.

I currently have 7 different systems but sometimes the bets overlap and I have made a few tweaks in the summer so now I want it to only place 1 bet even if it qualifies in more then one system.

For example the Germany league appears in 5 different systems.

I am already using signals so if it qualifies as a bet it will change the relevant signal from 0 to 1.

I was wondering is it possible to create a rule where Bet Angel can add up the value of all the signals and if its greater then 0 place a single bet

Thanks to anyone who responds

Cheers

Lee

[Dallas]

Are you always betting in a single market per fixture or can your system/s place bets in different markets on a match?

[leewillo75]

Thanks for the response Dallas.

Bets on this system are always placed in the 1.5 goals market. I use values from match odds and the 2.5 goals markets but Ive got that already sorted using stored values and have been using it for 2 to 3 seasons all ready.

Until Ive tweaked a few things this summer I only ever had duplicates in 2 systems, so it was always run the first system if the signal is 1 dont run the second system etc...

However with potentially 5 systems to check I was just wondering if there was a quicker way of doing it, ie run all the systems at the same time and change all the signals and then last rule just list all the signals and if the total is greater then zero place a bet

[jamesedwards]

Need some advice as not sure if this is possible or not.

Basically I run a model of laying under 1.5 goals in certain leagues.

I currently have 7 different systems but sometimes the bets overlap and I have made a few tweaks in the summer so now I want it to only place 1 bet even if it qualifies in more then one system.

For example the Germany league appears in 5 different systems.

I am already using signals so if it qualifies as a bet it will change the relevant signal from 0 to 1.

I was wondering is it possible to create a rule where Bet Angel can add up the value of all the signals and if its greater then 0 place a single bet

Thanks to anyone who responds

Cheers

Lee

If you use stored values rather than signals then you can save them at four different levels: selection, market, event, and Bet Angel. 'Event' level stores the value across all markets under that match loaded into Guardian. 'Bet Angel' level stores the value across all markets loaded into Guardian.

[leewillo75]

Need some advice as not sure if this is possible or not.

Basically I run a model of laying under 1.5 goals in certain leagues.

I currently have 7 different systems but sometimes the bets overlap and I have made a few tweaks in the summer so now I want it to only place 1 bet even if it qualifies in more then one system.

For example the Germany league appears in 5 different systems.

I am already using signals so if it qualifies as a bet it will change the relevant signal from 0 to 1.

I was wondering is it possible to create a rule where Bet Angel can add up the value of all the signals and if its greater then 0 place a single bet

Thanks to anyone who responds

Cheers

Lee

If you use stored values rather than signals then you can save them at four different levels: selection, market, event, and Bet Angel. 'Event' level stores the value across all under that match loaded into Guardian. 'Bet Angel' level stores the value across all markets loaded into Guardian.

thanks for the response. I havent got my brain into gear today so unless I am being stupid what you are suggesting is the following in effect.

Set up stored values across the game at Bet Angel level
Put all the different criteria into the rules
At the end create a rule saying change the stored value to one
Then create a rule at the end where it adds up the stored values from above and if its greater then 0 place a bet

[jamesedwards]

Need some advice as not sure if this is possible or not.

Basically I run a model of laying under 1.5 goals in certain leagues.

I currently have 7 different systems but sometimes the bets overlap and I have made a few tweaks in the summer so now I want it to only place 1 bet even if it qualifies in more then one system.

For example the Germany league appears in 5 different systems.

I am already using signals so if it qualifies as a bet it will change the relevant signal from 0 to 1.

I was wondering is it possible to create a rule where Bet Angel can add up the value of all the signals and if its greater then 0 place a single bet

Thanks to anyone who responds

Cheers

Lee

If you use stored values rather than signals then you can save them at four different levels: selection, market, event, and Bet Angel. 'Event' level stores the value across all under that match loaded into Guardian. 'Bet Angel' level stores the value across all markets loaded into Guardian.

thanks for the response. I havent got my brain into gear today so unless I am being stupid what you are suggesting is the following in effect.

Set up stored values across the game at Bet Angel level
Put all the different criteria into the rules
At the end create a rule saying change the stored value to one
Then create a rule at the end where it adds up the stored values from above and if its greater then 0 place a bet

If your bets are being triggered in the same market then it's probably easiest to add conditions that matched bets = 0 and unmatched bets = 0. Then as soon as one bet is triggered it will stop any further from being placed.

[leewillo75]

If you use stored values rather than signals then you can save them at four different levels: selection, market, event, and Bet Angel. 'Event' level stores the value across all under that match loaded into Guardian. 'Bet Angel' level stores the value across all markets loaded into Guardian.

thanks for the response. I havent got my brain into gear today so unless I am being stupid what you are suggesting is the following in effect.

Set up stored values across the game at Bet Angel level
Put all the different criteria into the rules
At the end create a rule saying change the stored value to one
Then create a rule at the end where it adds up the stored values from above and if its greater then 0 place a bet

If your bets are being triggered in the same market then it's probably easiest to add conditions that matched bets = 0 and unmatched bets = 0. Then as soon as one bet is triggered it will stop any further from being placed.

Just thinking though I sometimes trade them markets as well so if I put that condition in, its going to stop that function from working.

The automation is set up to place bets 5 mins before the kick off time

[jamesedwards]

thanks for the response. I havent got my brain into gear today so unless I am being stupid what you are suggesting is the following in effect.

Set up stored values across the game at Bet Angel level
Put all the different criteria into the rules
At the end create a rule saying change the stored value to one
Then create a rule at the end where it adds up the stored values from above and if its greater then 0 place a bet

If your bets are being triggered in the same market then it's probably easiest to add conditions that matched bets = 0 and unmatched bets = 0. Then as soon as one bet is triggered it will stop any further from being placed.

Just thinking though I sometimes trade them markets as well so if I put that condition in, its going to stop that function from working.

The automation is set up to place bets 5 mins before the kick off time

Then use a separate signal or stored value to 1 when a bet is triggered. Then use a condition that that signal or stored value is not set.

[leewillo75]

If your bets are being triggered in the same market then it's probably easiest to add conditions that matched bets = 0 and unmatched bets = 0. Then as soon as one bet is triggered it will stop any further from being placed.

Just thinking though I sometimes trade them markets as well so if I put that condition in, its going to stop that function from working.

The automation is set up to place bets 5 mins before the kick off time

Then use a separate signal or stored value to 1 when a bet is triggered. Then use a condition that that signal or stored value is not set.

Perfect thanks a lot