Is there an easier way of laying multiple runners if certian criteria are met other than making a rule for each runner in a race.
So instead of saying position 1 and the criteria and then new rule position 2 and the same criteria, and then doing this for what could be a large amount of runners.
Thanks in advance
Laying the multiple runners if certian criteria are met
Other than using "Lay or Back all selections" they need to be done individually
If you have included multiple conditions/values etc and then just want to apply to another selection rather than using the "green plus icon" to add a new rule it is sometimes quicker to use the "two green arrows icon" which duplicates the whole rule type including the triggers, arm times, parameters (stakes, offsets & stop losses etc) and also any conditions used and there values.
So once you have made the rule for the 1st selection you can then quickly create one for each by duplicating it and just changing the "applies to" section on the general tab
If you have included multiple conditions/values etc and then just want to apply to another selection rather than using the "green plus icon" to add a new rule it is sometimes quicker to use the "two green arrows icon" which duplicates the whole rule type including the triggers, arm times, parameters (stakes, offsets & stop losses etc) and also any conditions used and there values.
So once you have made the rule for the 1st selection you can then quickly create one for each by duplicating it and just changing the "applies to" section on the general tab